93 Cobra taillight lenses -Ford Tooling & PAINTED STRIPES

Technical Tips, Tricks and Q & A
NV93Cobra
Posts: 467
Joined: Thu Jul 05, 2012 5:04 pm
Location: Reno, Nevada

Re: 93 Cobra taillight lenses -Ford Tooling & PAINTED STRIPE

Post by NV93Cobra »

1993 SVT Cobra #4970
1993 Mustang GT (Sold)
NV93Cobra
Posts: 467
Joined: Thu Jul 05, 2012 5:04 pm
Location: Reno, Nevada

Re: 93 Cobra taillight lenses -Ford Tooling & PAINTED STRIPE

Post by NV93Cobra »

bill1024 wrote:I think I will give this a try. One question, how do you remove the lenses?
Is there an access in the trunk to get to screws holding the lenses in place?
you can remove the whole lens and housing assembly by removing the screws on the inside of the trunk... Or you can just remove the lens by pulling really hard on them. They're just held in with some tape and spring steel.
1993 SVT Cobra #4970
1993 Mustang GT (Sold)
97CasperCobra
Posts: 27
Joined: Thu Nov 06, 2014 12:51 pm

Re: 93 Cobra taillight lenses -Ford Tooling & PAINTED STRIPE

Post by 97CasperCobra »

BrentE wrote:Bad news! I received the lenses last night, and they are the same Daniel Carpenter units with the shitty tape stripes including the stupid one that is too long and goes over the area with the light bulb. I am seriously bummed out and pissed off. Waited forever for the pieces of shit and they sent me the same crap I could get overnight from a US dealer. Why in the fucks does Daniel Carpenter, who makes a lot of good stuff, even make these fucked up pieces of shit with the shitty fucking tape? What Cobra owner would put these cheesy pieces of fucksnot on his beloved Cobra, anyway?
Can you post pics of the lenses you received??


Sent from my iPhone using Tapatalk
Post Reply