Page 1 of 1
Ford Explorer Intake
Posted: Thu May 19, 2011 5:56 pm
by Cobrafan01
Hay guys, I have a question:
I have a upper and lower intake manifold that I pulled from a non running early 90's Ford Explorer. It's basically what came on the 93 Cobra.
I was wondering how much could I get for it if I got it professionally cleaned, and how much could I get for it as is (dirty).
Posted: Thu May 19, 2011 6:38 pm
by 1993cobra
my guess = 125
Posted: Thu May 19, 2011 6:59 pm
by WillyB93
The thing about them is they are everywhere for sale so I would say around 100 dollars seem pretty fair. That is about what I can get them for around here!
Posted: Thu May 19, 2011 7:04 pm
by Cobrafan01
Thanks guys!
Posted: Fri May 20, 2011 2:54 pm
by aaronlstiles
The only thing explorer Bringing good money is 96 GT-40 heads, they have a smaller CC chamber and make more power than both the P and the 93-gt40 heads. 96 Heads are hard to find though.
Posted: Sat May 21, 2011 6:59 pm
by Cobrafan01
aaronlstiles wrote:The only thing explorer Bringing good money is 96 GT-40 heads, they have a smaller CC chamber and make more power than both the P and the 93-gt40 heads. 96 Heads are hard to find though.
Hmm, that must be the gt 40x heads.
Posted: Wed May 25, 2011 10:11 am
by aaronlstiles
No, 96 Explorers ran regular GT-40 heads, only difference was a slightly smaller CC, single valve springs not dual and no emissions hole in the back of the heads. I have a nice set I just picked up. they are not X-heads, they are cast iron GT-40's